C&C Power has a full line of UL Listed UPS peripheral products available for use with any UPS. Battery disconnects, circuit breaker distribution, maintenance bypass panels, outlet panels, and remote status alarm panels are available for any UPS application.
Battery Disconnects
Battery disconnects isolate the battery string for added safety and ease of maintenance. C&C Power offers a full line of UPS battery disconnects available from 30 to 1,200 amps. These wall mount disconnects are available with your choice of breaker accessories including aux contacts, bell alarm contacts, shunt trip, and under voltage trip. Battery Disconnects info >>
Remote Power Panel
C&C Power’s Remote Power Panel (RPP) is a standalone AC power distribution unit that can accommodate up to eighty-four distribution circuit breakers. The RPP is available with several manufacturers standard AC circuit breaker panel boards. Choose from Cutler Hammer, GE, Siemens and Square D panel boards to suit your individual site needs. Remote Power Panel info >>
Maintenance Bypass Switch
C&C Power's 3 position wall mount Maintenance Bypass Switch is available in multiple configurations. The MBS allows the user to put the system into three modes: normal, test, and bypass. Each switch is make-before break type, insuring a connection at all times. The MBS is available from 40 to 63 Amps at 120-208 VAC single phase. Maintenance Bypass Switch info >>
Maintenance Bypass Breaker Cabinets
C&C Power offers Maintenance Bypass Breaker Cabinets available in multiple configurations. The MBBC allows the end user to safely isolate the UPS from utility power and from the load to perform regular service and maintenance. All of this is done while still maintaining power to your critical load. Maintenance Bypass Breaker Cabinets info >>
Outlet Panels
The C&C Power AC Outlet Panel is a stand alone unit used for UPS output distribution. The unit can be wall or floor mounted, and in some cases can be retro fit to the ups itself. Each position comes standard with circuit breaker protection. Each assembly is UL 1778 Listed. Outlet Panel info >>
Remote Status Alarm Panels
The C&C Power RSAP is used to remotely monitor the alarm condition and state of any UPS. The RSAP is wall mounted and can be located up to 1,000 feet from the UPS. The panel shows the current input status, the output that is being used as well as UPS fault conditions. The RSAP also has an audible alarm to warn of UPS fault conditions. Remote Status Alarm Panel info >>
